July 2013 2.7 Software 159
Press the NCV → iTNC soft key.
In the upper part of the window, you select the folder containing the *.zip
file of the new NC software. The folder contents are displayed in the lower
part of the window.
To switch to the lower part of the window, press the FILES soft key. To
return to the upper part of the window, use the PATH soft key. In the lower
part of the window, select the *.zip file of the new NC software with the
cursor keys and press ENT. Following that, the NC software exchange will
start.
All NC software versions that exist in the control are shown in the following
list box.
Select the new NC software with the arrow keys and press the SELECT soft
key. The selected NC software is marked with an asterisk (*) in the Sel
column. Confirm your selection with the YES soft key. The control activates
the selected NC software and performs a reset. Press the END key, the NO
soft key or the END soft key to exit the list box without making a new
selection.
If required, complete or delete the machine parameters.
While in the Programming and Editing operating mode, press the MOD key.
Enter the code number 95148 and confirm your entry with the ENT key.
While in the Machine-parameter programming mode, press the MOD key.
Press the UPDATE DATA soft key.
Press the ASC → BIN soft key to convert the files on the hard disk from
ASCII format back to binary format.
Read-in files which you had saved to a PC.
The NC software exchange is completed.
With the COPY SAMPLE FILES soft key, the HEIDENHAIN standard tables for
cutting data, the tilting-axis geometry, and the M-function macros as well as
a prototype for a freely definable table (contains only the column Name) can
be copied into the corresponding directories.
Equivalent file name extensions in ASCII and binary format
.H .H% .I .I% .T .T%
.TCH .TC% .D .D% .P .P%
.PNT .PN% .COM .CO% .CMA .CM%
To Next Page
Loading...
