HEIDENHAIN iTNC 530 HSCI - Double Swivel Head 45 Degrees

702 HEIDENHAIN Technical Manual iTNC 530 HSCI
Double swivel head
45°
In this example, the mechanical offset of a double swivel head is determined
by using a 3-D touch probe.
Input values for mechanical offset (via description table in the kinematics, ##
are the values to be determined):
NR KEY AXIS COORD ON/OFF FILE DOC
0 Trans Z ## Shift in Z axis
1 Trans X ## Shift in X axis
2 Trans A ## Rotate around A axis
3 Trans Z ## Shift in Z axis
4 MachAxis C Free tilting axis C
5 Trans A ## Rotate around A axis
6 Trans X ## Shift in X axis
7 MachAxis B Free tilting axis B
:
[END]
Step 1a
 Bring tilting axes B and C into 0° position
 Probe surface X1
 Set X = 0