1896 HEIDENHAIN Technical Manual iTNC 530 HSCI
Only four wires are required in a USB cable. Two for a power supply of 5 V
(with max. 500 mA / 2.5 W) and two for data transmission.
Structure of the USB cable:
USB data carriers
on the control
(Upgrade function –
FCL)
The USB interface of the control allows for convenient and fast exchange of
data. You can connect USB block devices, such as memory sticks, hard disks,
CD-ROM drives, to your control via the USB interface without having to reboot
the system. The data media can be accessed immediately after connection.
The control supports the following USB block devices:
Floppy disk drives with FAT/VFAT file system or ISO9660
Memory sticks with FAT/VFAT file system or ISO9660
Hard disks with FAT/VFAT file system or ISO9660
CD-ROM drives with FAT/VFAT file system or ISO9660
The control does not support USB devices with other file systems (e.g. NTFS).
If you try to connect such devices, the control will issue an error message.
It should basically be possible to connect all USB block devices with the
above-mentioned file systems to the control. If you nevertheless
encounter problems, please contact HEIDENHAIN.
Please note that the "Automatic Update" function on the control with USB
data carriers is independent of the Feature Content Level.
To Next Page
Loading...
