1358 HEIDENHAIN Technical Manual iTNC 530 HSCI
8.2.2 Large PLC window
Depending on the display mode, the large PLC window can be shown instead
of the graphic/status window, or even over the entire screen. The PLC
window can be combined with the PLC soft keys. See page 1372.
Select the display mode with the screen management key or with Module
9202.
Define the character size with the special command charsize = (see
"Special commands:" on page 1363). The specified position refers to the
lower left corner of the first character.
The content of the PLC window is defined in a screen mask – an ASCII file
containing format instructions and special commands:
Enter in Module 9210 the name of the screen mask to activate the PLC
window, or use the functions of the soft-key project file for display (see "PLC
soft keys" on page 1372).
Mode 1 Mode 2
SMALL 17 lines, 39 columns
0 = y16/x8
SMALL 27 lines, 79 columns
0 = y16/x8
MEDIUM 11 lines, 19 columns
0 = y24/x8
MEDIUM 18 lines, 39 columns
0 = y24/x8
LARGE 5 lines, 9 columns
0 = y48/x8
LARGE 9 lines, 19 columns
0 = y48/x8
To Next Page
Loading...
