HEIDENHAIN iTNC 530 HSCI - Configuration of the TNC Taskbar

1336 HEIDENHAIN Technical Manual iTNC 530 HSCI
Configuration of
the TNC taskbar
The TNC taskbar appears when you move the mouse pointer to the position
of the taskbar (standard setting: at bottom of screen). When the mouse
pointer is located over the TNC taskbar, press the right mouse key to open the
context menu for the configuration.
When the FULL configuration is active, the TNC taskbar contains the following
element buttons (from left to right):
 1: Show desktop button
 2: Pager for switching between the desktops and for moving windows
between the desktops with "drag and drop".
 3: Task list (shows all open windows)
 4: Context menu for configuring the TNC taskbar
 5: Time
To configure the TNC taskbar, proceed as follows:
 Press the ADVANCED SETUP soft key in the PLC operating mode.
 Press the CONFIGURE WINDOW MANAGER soft key.
 Move the mouse pointer over the position of the TNC taskbar until it
appears.
 Place the mouse pointer over the TNC taskbar and press the right mouse
key. To edit the properties of an element in the taskbar, place the mouse
pointer over the respective button in the taskbar.
This opens the context menu for configuring the TNC taskbar and the
selected element.
The context menu provides the following configuration options:
 Properties
Change the properties of the selected element.
 Move
Change the sequence of the buttons in the taskbar.
 Customize Panel
Change the properties of the complete TNC taskbar.