1334 HEIDENHAIN Technical Manual iTNC 530 HSCI
Configuration
with XFCE
If you want to create your own configuration containing the TNC taskbar, you
should first activate the FULL configuration. If you do not want your
configuration to contain the TNC taskbar, first select the SIMPLE
configuration.
Do not start the XFCE configuration until you have activated the respective
basic configuration.
The two supplied basic configurations SIMPLE and FULL are only changed
temporarily when you configure the window manager using the LOAD
CUSTOMIZED CONFIG soft key. The files containing the two basic
configurations are stored in the control and remain unchanged. This means
that you can call the basic configurations at any time by pressing the LOAD
MINIMUM CONFIG soft key or the LOAD MAXIMUM CONFIG soft key.
Direct saving of your own configurations is not possible. However, you can
save your own configurations by saving the complete PLC:\WINDOWMANAGER
directory via TNCremoNT, for example. If you copy the PLC:\WINDOWMANAGER
directory to other controls, the configuration saved in the directory will
become active.
To Next Page
Loading...
