HEIDENHAIN iTNC 530 HSCI - Additional Code for Transformation; Transformed Axis; “Tilt Working Plane” (Active Preset Table

768 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP7500 “Tilt working plane” (active preset table)
As of SW version:340 422-01, 340 480-02
Format: %xxxxxxxx
Input: Bit 0 – Switch-on "tilted working plane" function
0: Off
1: On
Bit 1 –
0: Angles correspond to the position of the tilting axes of the
head/table
1: Angles correspond to the spatial angle (the iTNC calculates
the position of the tilted axes of the head/table)
Bit 2 –
0: The tilting axes are not positioned with Cycle 19
1: The tilting axes are positioned with Cycle 19
Bit 3 – No function
Bit 4 – No function
Bit 5 – Test of the tilting axis during "datum setting" in X, Y and Z
0: Current tilting-axis position must fit to the defined tilting
angles
1: No test
Bit 6 –
0: Spatial angle C is realized through a rotation of the coordinate
system
1: Spatial angle C is realized through a rotation of the table
Bit 7 – No function
Bit 8 – No function
MP7510 Transformed axis
Format: %xxxxxx
Input: 0: End of the transformation sequence
Bit 0 corresponds to axis X
Bit 1 corresponds to axis Y
Bit 2 corresponds to axis Z
Bit 3 corresponds to axis A
Bit 4 corresponds to axis B
Bit 5 corresponds to axis C
MP7510.0–14Transformation 1 to transformation 15
MP7520 Additional code for transformation
Format: %xx
Input: Bit 0 – Tilting axis
0: Swivel head
1: Tilting table
Bit 1 – Type of dimension in MP7530.x
0: Incremental dimension for swivel head
1: Absolute with respect to the machine datum for tilting table
MP7520.0–14Transformation 1 to transformation 15