1712 HEIDENHAIN Technical Manual iTNC 530 HSCI
9.4.3 MGROUPS.SYS
In the system files PLC:\MGROUPS.SYS and PLC:\MSPLIT.SYS, you define
the M functions to be output after a block scan (see "Returning to the contour"
on page 1244).
9.4.4 MSPLIT.SYS
M functions that are effective in several groups are divided in the MSPLIT.SYS
file into function components (see "Returning to the contour" on page 1244).
9.4.5 PLCSOFTK.SYS
Path for the file names of the PLC soft-key pictures. (See "PLC soft keys" on
page 1372.)
9.4.6 CYCLE.SYS
Definition of the soft-key structure, if you have integrated OEM cycles. This
file is created automatically by the PC software CycleDesign (see OEMCYC
directory).
9.4.7 TNC.SYS
The end user can define certain paths and functions in the TNC:\TNC.SYS file:
TMAT = <Path for list of tool materials>
WMAT = <Path for list of workpiece materials>
PCDT = <Path for cutting data tables>
REMOTE.TNCPASSWORD = <Password for LSV2 access>
REMOTE.TNCPRIVATEPATH = <Path to be protected by the password>
REMOTE.PERMISSION = <computer>
External access to the control via LSV2 can be limited to specified
computers.
If the entry REMOTE.PERMISSION = <computer>;<computer> exists in the
TNC.SYS file, then only the computers listed will be granted access to the
control. The entry can be either the names or IP addresses of computers
and must be separated by semicolons. Access to the control is refused if the
REMOTE.PERMISSION entry exists in the TNC.SYS file but the computer is
not listed. If the REMOTE.PERMISSION entry does not exist, then every
computer can access the control.
PR.LINESLOCKED = <line number>
You can write-protect line of the preset table. A write protection for
individual lines or entire areas in the preset table can now be set by an entry
of PR.LINESLOCKED = (e.g. PR.LINESLOCKED = 1,4-8,22 ). Write-protection
can be activated only for the first 255 lines of the preset table. Protected
lines are indicated in the editor by a different color.
To Next Page
Loading...
