HEIDENHAIN iTNC 530 HSCI - Software Exchange Via Remote Operation; Soft Keys for Update Functions

158 HEIDENHAIN Technical Manual iTNC 530 HSCI
Software exchange
via remote
operation
Update via remote operation
How to perform an update via remote operation:
 In the Programming and Editing mode of the iTNC, press the MOD key.
 On the iTNC, activate remote maintenance by pressing the Service ON soft
key.
A service request is triggered and a connection is established.
 Transmit the setup.elf and setup.zip files to a suitable directory on the
control (e.g. TNC:\update).
 Continue the update via remote operation as described under "Manual
update".
Notes on updating via remote operation
 If remote maintenance is active when the update is started, the remote
maintenance is deactivated (this does not affect the current remote
operation).
 After the reboot or after the update was canceled due to an error, a service
request is triggered. The service request information indicates whether the
update was successful.
 If the control does not boot due to missing or incorrect machine parameters,
a service request is triggered until the "power interrupt" stage of the boot
process is reached.
Soft keys for update
functions
Soft key Function
Convert the files on the hard disk from binary format to ASCII
format and save nonvolatile markers in the PLCMEM.A file.
Convert the files on the hard disk from ASCII format to binary
format and save nonvolatile markers in the PLCMEM.A file.
Copy cutting-data tables, tables for tilting-axis geometry, and
the table of M-function macros from the SYS partition into the
corresponding directories of the TNC or PLC partition, and
create prototypes of the tables.
Activate or delete existing NC software.
Exchange NC software.