HEIDENHAIN iTNC 530 HSCI - Angular Errors of Linear Axes; Geometry Errors of Axes

666 HEIDENHAIN Technical Manual iTNC 530 HSCI
Geometry errors of
axes
There are basically two types of error – Component error and position error:
Component errors – deviations from the ideal movement – are identified by
three characters (e. g. EAX) according to the standard ISO 230-1. The
characters designate position functions of the axis under consideration.
 1st character (E): Identifier of the component error
 2nd character (e.g. A): Error direction
 3rd character (e.g. X): Axis under consideration
Position errors – deviations from the ideal axis position– are also identified by
three characters ((e. g. X0C) according to the standard ISO 230-1. These
characters designate constants.
 1st character (e.g. X): Error direction
 2nd character (0): Identifier of the position
 3rd character (e.g. X): Axis under consideration
Angular errors of
linear axes
Position error (angle) between linear axes. Example:
 Principal axis X
 1st minor axis Z
 2nd minor axis Y
A0Y
C0Y
B0Z
X
Y
Z