HEIDENHAIN iTNC 530 HSCI - Operating Modes

July 2013 8.1 Display and operation 1165
8.1.2 Operating modes
The iTNC features main operating modes, background operating modes, and
the alternative smarT.NC operating mode. The background operating modes
are each called from the main operating modes.
Each operating mode and the varied corresponding information can be
interrogated and evaluated via the PLC.
The "Machine" and "Editor" operating modes can be interrogated via markers,
W272 and a PLC module (see "Module 9035 Read status information" on page
1162), and the alternative smarT.NC operating mode can be interrogated via
Marker M4163 in combination with W272.
Set Reset
M4150 "Manual Operation" main operating
mode is active
NC NC
M4151 Electronic Handwheel main operating
mode is active
NC NC
M4152 Operating mode marker
 Positioning with Manual Input
main operating mode (if smarT.NC
inactive --> M4163 = 0)
 RUN ACTIVE UNIT smarT.NC main
operating mode (if smarT.NC active -->
M4163 = 1)
NC NC
M4153 Operating mode marker
 Program Run, Single Block
main operating mode (if smarT.NC
inactive --> M4163 = 0)
 RUN SINGLE UNITS smarT.NC main
operating mode (if smarT.NC active -->
M4163 = 1)
NC NC
M4154 Operating mode marker
 Program Run, Full Sequence
main operating mode (if smarT.NC
inactive --> M4163 = 0)
 RUN ALL UNITS smarT.NC main
operating mode (if smarT.NC active -->
M4163 = 1)
NC NC
M4155 Traversing the Reference Points
main operating mode is active
NC NC
M4163 Alternative operating mode "smarT.NC"
is active
NC NC
M4186 NC program was started in the Test Run
mode
NC NC