July 2013 8.1 Display and operation 1325
"State" window
(at lower right)
Current status of selected HSCI/PROFIBUS component.
Value: Operand value of the terminal in decimal and hexadecimal code
Text: Error texts that appear when an error occurs; otherwise, no display.
The texts displayed are error-specific texts from the HDD/GSD file or the
error information configured in IOconfig.
Display of S status (31 bits) in HEX code. The meaning is displayed in
abbreviated form below the S status.
You can use the following tables to look up the meaning of the individual S
status bits. To do this, you need to convert the displayed HEX code to a binary
number. Example:
S-Status: 0x00010103
0000 0000 0000 0001 0000 0001 0000 0011
0Bit 31
Meaning of S-Status:
Bit 17 = 1: Watchdog SPL Channel B
Bit 8 = 1:
Fatal Error MOP
Bit 1 = 1: Emergency Stop Channel B
Bit 0 = 1: Emergendy Stop Channel A
Safe status
bit
Signal Meaning
0 –ES.A Emergency stop channel A
The control has initiated the SS1 alarm
reaction.
1 –ES.B Emergency stop channel B
The control has initiated the SS1 alarm
reaction.
2 –ES.A.HW Emergency stop channel A, handwheel; no
function in controls without functional
safety.
The control has initiated the SS1 alarm
reaction.
3 –ES.B.HW Emergency stop channel B, handwheel; no
function in controls without functional
safety.
The control has initiated the SS1 alarm
reaction.
4 –STO.A.MC.WD Watchdog of MC software, switch-off of
inverters, A channel (with functional safety
(FS): switch-off of FS outputs).
The control has initiated the SS1 alarm
reaction.
5 –STOS.A.MC Spindle is switched off by the MC,
A channel, STOS.A.G is initiated
(CC: switch-off of spindle); no function in
controls without functional safety (FS)
To Next Page
Loading...
