HEIDENHAIN iTNC 530 HSCI - Page 1324

1324 HEIDENHAIN Technical Manual iTNC 530 HSCI
Comment Name of the slave (for slaves and
slave modules) or terminal description
 Master entries:
• "Configuration file"
 Master/slave entries:
•"Name"
• "Hardware ID"
• "Hardware serial number"
• "Firmware ID"
• "Firmware timestamp"
• "Configuration file"
 Terminal entries:
• "Comment"
•"Pin name"
• "Plan page"
• "Order number"
Option Designation of the option Slave / slave module entered in "block"
Bus address HSCI/PROFIBUS address Slave entered in "HSCI/PROFIBUS address"
Slot Slot number of the slave module
Terminal Terminal number Determined from the terminals entered in "I/O
offset" and "I/O bit"
Operand Operand designation Terminal entered in "PLC operand address"
Order no. Order number "Order number" entered for the terminal
Plan page Wiring diagram page "Page" entered for the terminal
Pin name Terminal name "Pin name" entered for the terminal
Field Function Formed from...