1078 HEIDENHAIN Technical Manual iTNC 530 HSCI
7.4.3 Combination of several CC 61xx controller units
Combination of several CC 61xx controller units
Two drive-control motherboards are housed in one CC 6108 or CC 6110. Both
boards must be connected to the supply bus via the connectors X69A and
X69B. A short ribbon cable (ID 325816-15) with three connectors for X69 is
therefore included with either of the two CCs. Two of the connectors are
connected to X69A and X69B of the CC, respectively. The third connector of
the cable serves to establish the connection to X69 of the power supply
module.
The ribbon cable with ID 325816-24 (100 mm) must be used for connecting
two CC 6106 controller units.
However, if you want to arrange two CC 61xx controller units other than the
CC 6106 controller unit next to each other in one row, you need to use the
ribbon cable with ID 325816-22. This cable is required for the following
configurations: 2 x CC 6108, 2 x CC 6110 or CC 6110 with CC 6108. The four
connectors X69 of the CCs are then connected via the additional accessory
cable. The fifth connector of the cable is used to establish the connection to
X69 of the power supply module.
Ribbon cable
ID 325816-15
ID 325816-24
ID 325816-22
To Next Page
Loading...
