July 2013 2.5 Overview of components 93
2.5.5 SPI expansion modules
Expansion module for analog axes/spindles in the HSCI system
Expansion module for analog axes/spindles in
the HSCI system:
CMA-H 04-04-00:
Module for controlling analog axes or
spindles. The CMA-H is inserted in one of the
SPI slots on the bottom of the controller
units. The analog control loop outputs are
accessed only via the NC.
As of software version 60642x-02,
interpolated movements of analog axes with
other axes are usually possible. However,
please discuss such applications with your
contact person at HEIDENHAIN beforehand.
CMA-H 04-04-00 ID 688721-xx
To Next Page
Loading...
