HEIDENHAIN iTNC 530 HSCI - ID 670304-XX HR 520 FS Handwheel

July 2013 2.5 Overview of components 109
HR 520 handwheel
 Display for operating mode, actual position
value, programmed feed rate and spindle
speed, error messages
 Graphic display,
resolution: 128 x 64 pixels, 6-line display
 Spindle speed and feed-rate override
 Selection of axes via keys or soft keys
 Actual position capture
 NC start/stop, spindle start/stop
 6 freely programmable PLC keys with LED
 Keys for traverse direction
 Exchangeable snap-on keys for PLC functions
and maintenance
 Integrated permissive buttons and emergency
stop button (24 V)
 Magnetic holding pads
 Mount for attaching the handwheel to the
machine (ID 591065-xx)
 Weight: Approx. 1 kg
ID 670302-xx HR 520 handwheel
ID 670303-xx HR 520 handwheel with detent
HR 520FS handwheel
 Graphic display,
resolution: 128 x 64 pixels, 6-line display
 Six NC keys
 Six PLC keys with LEDs that are controlled
through the PLC
 Two override potentiometers (feed rate and
spindle speed)
 Two cross-circuit-proof permissive buttons
 Exchangeable snap-on keys for PLC functions
and maintenance
 Integrated emergency stop button
 Magnetic holding pads
 Additional snap-on keys for spindle stop,
spindle left, and spindle right are included with
the handwheel
 Weight: Approx. 1 kg
ID 670304-xx HR 520FS handwheel
ID 670305-xx HR 520FS handwheel with detent