July 2013 2.7 Software 163
Entries in the
log file
If errors occur during conversion, the TNC will display error messages and
record them in the log file. During the NC software switch, the name and path
of a log file can be entered in the header after Path =; the extension .A must
be used. If no entry is made in this line, the file TNC:\CVREPORT.A is created.
Each error message contains:
Error message
Error code
Error cause
File concerned
Example:
==================================================
ERROR :REMANENT PLC DATA NOT RESTORED
ERRNO :2
ERROR MESSAGE :Program name not found
FILE :PLCMEM.A
==================================================
Error message Meaning
CANNOT OPEN DIRECTORY File could not be opened
REMANENT PLC DATA NOT
RESTORED
No access to the file PLCMEM.A
NOT ENOUGH SPACE Too little free memory on the hard disk
CONVERSION BIN ASC FAILED A binary file has an incorrect format (e.g.,
binary format from an old NC software)
CONVERSION ASC BIN FAILED An ASCII file on the hard disk is incorrect
To Next Page
Loading...
