July 2013 8.1 Display and operation 1289
Standard log The standard log serves as a troubleshooting aid. There are 4 MB of memory
available for this purpose.
All entries in the log are marked with the momentary date and time.
You can read out the standard log in two ways:
After entering the code word LOGBOOK, enter the path and name of an
ASCII file and the time and date from which the log should record, as well
as the time and date up to which it should record. After that, an ASCII file is
generated and opened with the log entries.
The PC software programs PLCdesign, TNCremo, and TNCremoNT offer
you several functions for reading out the log.
Entry Description
RESET Powering up the control
BERR Blinking error message
BREG Register contents with a blinking error message
ERR Error messages
P: PLC error message with the line number in the
PLC error text file
N: NC error message with number
Power fail interrupt: Control was switched off by
a POWERFAIL
Result of the file system test (in case the control
was not properly shut down previously)
ERR dosfsck -a Check of the PLC: and TNC: hard-disk partitions if the
control was not shut down correctly
INFO "xxx" "xxx": Name of the control process that enters the
information in the log
PLC
SYS
MAIN
REMO
CTRL
SMARTNC
SMARTNC_LDF
BDEHAN
SOKY
GEO
PYTHON
FIXTURE
FILEMAN
INFO CTRL KINEMATIC Active tool with tool number, radius (R =) and length
(L =)
INFO CTRL collision Status of collision monitoring in the Manual and
Automatic operating modes
INFO CTRL REG
AXIS xx START REF=yy
Position yyyy of axis xx at start of movement
To Next Page
Loading...
