HEIDENHAIN iTNC 530 HSCI - Meanings of the Signals under Power Module; Status; Meanings of the Signals under Speed Controller; Overview

July 2013 8.1 Display and operation 1317
Meanings of the
signals under
"power module /
status"
Meanings of the
signals under
"speed controller /
overview"
Signal Meaning Colors
Power module ready (LT-
RDY)
The power module is ready:
 Safety relay is on
 Main contactor is on
 SH1 (MC) is "High"
 No error from the power module
 Gray: No information about
the signal available
 Green: Power module is
ready
 Red: Power module reports
"not ready"
Switch-off power module
(IGBT)
The signal shows that the IGBT in the
power module has been switched off.
 Gray: No information about
the signal available
 Green: No power module
switch-off (IGBT)
 Red: Power module switch-
off (IGBT)
Power module
temperature
The signal reports the status of the heat
sink temperature in the power module:
Either it is OK or too high.
 Gray: No information about
the signal available
 Green: Temperature of
power module OK
 Red: Temperature of power
module too high
Information Meaning Colors
Direction
(only available in
motor encoder
test)
Results of the test for the
direction of rotation.
 Green: Direction of
counting and rotation
are the same (OK)
 Red: Direction of
counting and rotation
differ (error)
Amplitude Result of the test of the
speed encoders' signals
 Green: Signal
amplitude within the
tolerance (OK)
 Red: Signal amplitude
outside the tolerance
(error)