July 2013 8.1 Display and operation 1299
DriveDiag The iTNC 530 also features the diagnostic tool "DriveDiag".
To start DriveDiag:
While in the Programming and Editing operating mode, press the MOD key.
Press the DIAGNOSIS soft key.
Press the DRIVE DIAGNOSIS soft key.
Press the DRIVE DIAG soft key.
This opens an additional task for the DriveDiag diagnosis tool.
The structure of the drive system is displayed on the left side of the screen in
a tree structure. Detailed information on the currently selected component is
displayed on the right side of the screen.
To navigate within the tree structure (left side of screen) and the tabs (right
side of screen), use the arrow keys. Use the ENT key to move from the left
side of the screen to the right side of the screen. Use the END key to move
from the right side of the screen back to the left side of the screen. If the
cursor is already located on the left side of the screen, you can exit DriveDiag
with the END key.
To switch back to the screen of the control or to DriveDiag, press the screen
switchover key.
To Next Page
Loading...
