HEIDENHAIN iTNC 530 HSCI - Buffer Battery

294 HEIDENHAIN Technical Manual iTNC 530 HSCI
3.21 Buffer battery
Battery type: 1 lithium battery, type CR 2450N (Renata), ID 315878-01
If the voltage of the buffer battery falls below 2.6 V, the error message
Exchange buffer battery appears. If the voltage does not rise above 2.6 V
again, the error message is reactivated after 30 minutes.
To exchange the battery:
 The buffer battery is on the motherboard of the MC 6xxx.
 Loosen the screws securing the housing cover of the MC 6xxx.
 Remove the cover.
 The buffer battery is at the border of the PCB:
In the MC 6x41, it is next to the slot for the HDR:
Note
Make a data backup before changing the buffer battery.
Danger
When exchanging the buffer battery, remember:
 Switch off the machine and the TNC.
 The buffer battery may be exchanged only by trained personnel.
 When exchanging the buffer battery, ensure electrostatic discharge
protection. Improper handling can result in damage to the components or
assemblies due to ESD!
Buffer battery in
MC 6x41