HEIDENHAIN iTNC 530 HSCI - TE 745 (FS) Keyboard Unit

July 2013 3.38 TE 745 (FS) keyboard unit 373
3.38 TE 745 (FS) keyboard unit
TE 745 (FS), NC operating panel in stainless-steel design (corresponds to TE 740),
machine operating panel is integrated (same as MB 720), for 19 inches, with touchpad
TE 745 (FS) pin layout
TE connector Function
X2: USB Type B USB connection with BF 760. The TE 745 is connected with the USB hub of the
BF 760. The maximum permissible cable length for this USB connection is 3 m.
The USB hub of the TE 745 only supports USB 1.1.
X40: USB Type B USB connection for execution of the USB connection from the BF 760 to the
USB connector in the front of the TE
X1 Screen soft keys of BF 760 X3 via ribbon cable to keyboard unit X1
X60 Potentiometer of keyboard unit via ribbon cable (enclosed) to machine operating
panel X10
S, X11 Connection for spindle-speed override potentiometer
(pre-assigned by HEIDENHAIN)
F, X19 Connection for feed-rate override potentiometer. There are two connections—
preassigned by HEIDENHAIN depending on the arrangement of the feed-rate
potentiometer.
E, X17 Connection for rapid-traverse override potentiometer. There are two
connections—preassigned by HEIDENHAIN depending on the arrangement of
the rapid-traverse potentiometer.
F, X16 Connection for feed-rate potentiometer, alternative to X19
E, X22 Connection for rapid-traverse override potentiometer, alternative to X17
X27 Not used
X7
X6
X31
X30
X101
X101
X10
X500
X502
X23
X14
X15
X2
X1
X60
X40
X17
X19
E
F
X27
E
F
S
X11
X16
X22