July 2013 7.4 Single-speed, double-speed, PWM frequency 1079
If several CC 61xx controller units are connected via a cable with ID 325816-xx,
the +5 V power must usually only be supplied by connector X74 of the
rightmost CC controller unit. The +5 V supply must be tested, however, see
page 235.
Two drive-control motherboards are housed in one CC 6108 or CC 6110. The
HSCI bus must be forwarded from one board to the other via the connectors
X500A and X502B. A short HSCI cable (approx. 20 cm) is therefore included
with either of the two CCs.
ID 325816-24
connecting two
CC 6106
ID 325816-22
connecting two
CC 6108
Ribbon cable
To Next Page
Loading...
