July 2013 7.7 Special functions 1095
By the customer: Selecting the machining method optimized for the load
Entering the load class (or mass) before machining, or determining the load
class with the NC macro from the OEM as described above.
Activating the correct machine-parameter subfile depending on the
measured result
FN 17 SYSWRITE ID 1020 NR 1 = <line number> (when using the keyword
MPFRAGMENTFILE = <path/file name> in OEM.SYS)
Deactivating the machine-parameter subfile
FN 17 SYSWRITE ID 1020 NR 2
within an NC macro, which is run when a program is concluded with M02,
M30 or END PGM (keyword RUNENDPGM in NCMACRO.SYS). In the
Manual operating mode, this macro must also be saved in the M function
table under M02 and M30.
Retention forces and friction forces are included in the measured value
Deviations in the utilization due to oscillations or torque ripple are
included in the measured value
The override of the feed-rate potentiometer is taken into account
The determined value depends on the axis parameters. Use axis
parameters with stable behavior for the determination
To Next Page
Loading...
