1170 HEIDENHAIN Technical Manual iTNC 530 HSCI
The NC measures the time for Control on, Machine on and Program run.
For PLC operating times 1 to 13:
Start with Module 9190.
Stop with Module 9191.
Except for Control on, all operating times are saved during a hard-disk
backup. see "Data backup" on page 179.
With the following modules you can evaluate and change the operating times:
Module 9190: Starting the operating times
Module 9191: Stopping the operating times
Module 9192: Reading the operating times
Module 9193: Setting the operating times
Module 9194: Alarm when operating times are exceeded
MP7237 Display and reset the operating times
Format: %xxxxxxxxxxxxx
MP7237.0 Displaying PLC operating times
Input: Bits 0 to 12 represent PLC operating times 1 to 13
0: Do not display
1: Display
MP7237.1 Reset PLC operating times with code number 857282
Input: Bits 0 to 12 represent PLC operating times 1 to 13
0: Do not reset
1: Reset
MP7237.2 Reset PLC operating times with code number 857282
Input: Bit 0 – Nonfunctional
Bit 1 – "Machine on" operating time
Bit 2 – "Program run" operating time
0: Do not reset
1: Reset
MP7238.0-12 Dialog messages for PLC operating times 1 to 13
Input: 0 to 4095
Dialog no. from the file PLCDIALOG= (OEM.SYS)
To Next Page
Loading...
