1240 HEIDENHAIN Technical Manual iTNC 530 HSCI
FN 18: SYSREAD Q1 = ID 332 NR 8 IDX1
Returns the max. value of handwheel superimpositioning for the X axis
FN 18: SYSREAD Q1 = ID 332 NR 9 IDX10
Returns the actual value of handwheel superimpositioning for the VT axis
FN 17 functions:
FN 17: SYSWRITE ID 332 NR 1 IDX0 = 45
Sets the basic rotation to 45 degrees
FN 17: SYSWRTIE ID 332 NR 2 IDX3 = 9
Performs Z-axis movements with the W axis
FN 17: SYSWRITE ID 332 NR 3 IDX2 = 1
Sets "mirroring" for the Y axis
FN 17: SYSWRITE ID 332 NR 4 IDX1 = -10
Sets –10 as the shift value in X
FN 17: SYSWRITE ID 332 NR 5 IDX0 = -45
Sets the rotation to –45 degrees
FN 17: SYSWRITE ID 332 NR 6 IDX0 = 200
Sets the feed rate override to 200 %
FN 17: SYSWRITE ID 332 NR 7 IDX3 = 0
Undoes disabling of the Z axis
FN 17: SYSWRITE ID 332 NR 8 IDX2 = 100
Sets the max. value of the Y axis handwheel superimpositioning to 100
FN 17: SYSWRITE ID 332 NR 9 IDX10 = 5
Sets the actual value of the VT axis handwheel superimpositioning to 5
To Next Page
Loading...
