HEIDENHAIN iTNC 530 HSCI - Page 1310

1310 HEIDENHAIN Technical Manual iTNC 530 HSCI
Motor encoder test
(available only after the code number 688379 or 807667 has been entered)
Diagram tab:
After the test has been completed, the result is displayed in a diagram.
Two green lines in the diagram mark the minimum and maximum height of
the speed encoder signals. The red line shows the measured signals.
Motor encoder test
Overview tab:
Begin the test by pressing the START MEASUREMENT button.
 Status information about various signals, see page 1317
The plain text displayed in the lower part of the screen provides additional
information about the test results.
Position encoder test
Diagram tab:
After the test has been completed, the result is displayed in a diagram. Two
green lines in the diagram mark the minimum and maximum height of the
speed encoder signals. The red line shows the measured signals.
Position encoder test
Overview tab:
Begin the test by pressing the START MEASUREMENT button.
 Status information about various signals, see page 1317
The plain text displayed in the lower part of the screen provides additional
information about the test results.
Drive test
(available only after the code number 688379 or 807667 has been entered)
Test tab:
Begin the test by pressing the START MEASUREMENT button.
 Status information about various signals, see page 1318
The plain text displayed in the lower part of the screen provides additional
information about the test results.
Icon Icon Icon Function