HEIDENHAIN iTNC 530 HSCI - Page 1366

1366 HEIDENHAIN Technical Manual iTNC 530 HSCI
ERRQUE=n [/c] [/e] [/l] [/n] [/s]
Links a table with the messages waiting in the PLC error queue.
n: Number of table lines
/c: Table is updated cyclically.
/e: Paging in tables, message can be acknowledged with CE.
/l: Alternative to /n. Line number before the error text. Position in the
error source is displayed.
/n: Alternative to /l. /l has priority.
Error number before the error text.
Line number of the .PET table is displayed.
/s: Three-digit status field with the following information:
C:CE possible
S: Message causes a stop
E: Message causes an emergency stop
F: Resets the feed-rate enabling
0 to 2: Priority
REFRESH=n
Time interval in [ms]
All variables with the /c switch are checked and, if required, redisplayed.
Value range: 100 to 100 000 [ms]
Default setting: 400 ms
KBD
This command is needed only if relatively long texts are to be moved with the
cursor keys. It assigns the keyboard to the PLC window as long as it is visible
on the screen.
If the page limits were defined with \f, it is possible to scroll and to page up
and down with the arrow keys.
If the mask contains elements with the /e or /i switch, the keyboard is
automatically assigned to the PLC window. In this case the arrow keys jump
from input field to input field.
Soft keys, screen switch-over keys, operating mode keys, special function
keys (MODE, PGM-MGT, CALC) always remain assigned to the NC.
LINE=xpix, ypix
Draws a line from the current position to the designated position. The
designated position is then assumed as the current position.
xpix = Distance in pixels from the left edge of the current page
ypix = Distance in pixels from the upper edge of the window
ILINE=xpix, ypix
Draws a line from the current position to a position that is offset by xpix,
ypix.
xpix, ypix = Line lengths in x, y.
Then the current position is corrected by xpix, ypix.
LINESTYLE=SOLID/DASH/LDASH
Defines the line type for the LINE/ILINE command.
SOLID = Solid line
DASH = Dashed line (interrupted line)