July 2013 8.8 Electronic handwheel 1511
With the exception of the function keys A, B and C, all keys are evaluated by
the NC.
With MP7670.x, select the subdivision factors for slow, medium and fast
speed.
With MP7671.x, define the values for slow, medium and fast speed. The
speed is entered as a percentage of the manual feed rate (MP1020.x).
If MP7641 bit 1 is set, then with MP7672.x you can set the distance per
handwheel step for the HR 410. Different distances per step can be set for
three speed stages.
Evaluation of the keys via the PLC: MP7645.0 = 1
All keys are evaluated by the PLC.
Module 9036 sets the handwheel axis and handwheel subdivision.
With W766 you can influence the feed rate of the axis direction keys.
O96
I160
O97
I161
O98
I162
O99
I163
O100
I164
O103
I167
O104
I168
O105
I169
O106
I170
I171 I172
O109
I173
O110
I174
O111
I175
To Next Page
Loading...
