HEIDENHAIN iTNC 530 HSCI - Page 1550

1550 HEIDENHAIN Technical Manual iTNC 530 HSCI
Example Here you see the print mask of Cycle 421 for English and German.
L_ENGLISH;
"-------------------------------------------------------------------
-----"; "************ Measuring Log for Probing Cycle 421: Hole
Measuring **********";
"Date: %02.2d-%02.2d-%4d",DAY,MONTH,YEAR4;
"Time: %2d:%02.2d:%02.2d",HOUR,MIN,SEC;
"Measuring program: %S",CALL_PATH;
“-------------------------------------------------------------------
-------“;
“ “;
"Nominal values: Center in 1st axis: %6.4LF", Q273;
" Center in 2nd axis: %6.4LF", Q274;
" Diameter: %6.4LF", Q262;
““;
“-------------------------------------------------------------------
--------“;
““;
"Given limit values:Maximum dimension for center in 1st axis: %6.4LF",
Q31;
" Minimum dimension for center in 1st axis: %6.4LF",
Q32;
““;
" Maximum dimension for center in 2nd axis: %6.4LF",
Q33;
" Minimum dimension for center in 2nd axis: %6.4LF",
Q34;
““;
" Maximum dimension for hole: %6.4LF", Q275;
" Maximum dimension for hole: %6.4LF", Q276;
““;
“*******************************************************************
********“;
““;
"Actual values: Center in 1st axis: %6.4LF", Q151;
" Center in 2nd axis: %6.4LF", Q152;
" Diameter: %6.4LF", Q153;
““;
“-------------------------------------------------------------------
--------“;
““;
"Deviations: Center in 1st axis: %6.4LF", Q161;
" Center in 2nd axis: %6.4LF", Q162;
" Diameter: %6.4LF", Q163;
““;
“*******************************************************************
********“;
““;
"Further measuring results: measuring height: %6.4LF", Q261;
““;
"**************************** End of Measuring Log
****************************";
L_GERMAN;
"-------------------------------------------------------------------
--------"; "************** Messprotokoll Antastzyklus 421 Bohrung