July 2013 8.13 Touch probe 1557
The measuring tolerance is changed according to the following table:
MP6507=2: Constant probing feed rate
The probing feed rate remains the same, regardless of the tool radius. The
absolute measuring error grows proportionally with the size of the tool radius.
r: Tool radius [mm]
MP6510.0: Max. permissible measuring error [mm]
v: Probing feed rate [m/min]
MP6570: Maximum permissible surface speed of the tool edge [m/min]
MP6500 Tool measurement with TT table touch probe
Format: %xxxxxxxxxxxxx
Input: Bit 4 –
0: Automatically determine speed
1: Always use minimum spindle speed
MP6507 Calculation of the probing feed rate
Input: 0: Calculation of the probing feed rate with constant tolerance
1: Calculation of the probing feed rate with variable tolerance
2: Constant probing feed rate
MP6520 Probing feed rate for tool measurement with non-rotating
tool
Input: 1 to 10 000 [mm/min]
MP6570 Max. permissible surface cutting speed at the tooth edge
Input: 1.0000 to 129.0000 [m/min]
MP6572 Maximum permissible speed during tool measurement
Input: 1 to 1000 [min
–1
]
0: 1000 [min
–1
]
Tool radius Measuring tolerance
Up to 30 mm MP6510.0
30 mm to 60 mm 2 · MP6510.0
60 mm to 90 mm 3 · MP6510.0
90 mm to 120 mm 4 · MP6510.0
Messtoleranz
r
5 [mm]
----------------------
MP6510.0⋅=
v
MP6570 MP6510
⋅
2 π 10
-3
⋅⋅
--------------------------------------
=
To Next Page
Loading...
