HEIDENHAIN iTNC 530 HSCI - Page 1610

1610 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP7480 Output of the tool or pocket number
MP7480.0 With a TOOL CALL block
Input: 0: No output
1: Tool number output only when tool number changes
2: Tool number output for every TOOL CALL block
3: Pocket number and tool number output only when tool
number changes
4: Pocket number and tool number output for every TOOL CALL
block
5: Pocket number and tool number output only when tool
number changes. Pocket table is not changed.
6: Pocket number and tool number output for every TOOL CALL
block. Pocket table is not changed.
MP7480.1 With a TOOL DEF block
Input: 0: No output
1: Tool number output only when tool number changes
2: Tool number output for every TOOL DEF block
3: Pocket number and tool number output only when tool
number changes
4: Pocket number and tool number output for every TOOL DEF
block
MP7482 Pocket coding of the tool magazines
Format: %xxxxxxxx
0: Variable pocket coding
1: Fixed pocket coding
Input: Bit 0: Magazine 1
Bit 1: Magazine 2
Bit 2: Magazine 3
Bit 3: Magazine 4
Bit 4: Magazine 5
Bit 5: Magazine 6
Bit 6: Magazine 7
Bit 7: Magazine 8