1628 HEIDENHAIN Technical Manual iTNC 530 HSCI
M → S:
Special tool follows
a manual tool
With this change sequence, two pocket numbers or two tool numbers must
be transferred in succession. M4520 indicates that another TOOL CALL strobe
(M4073) will follow. Regardless of M4541 and M4540 or MP7481.x, the
pocket number –1 and tool number zero are transferred first.
Tool number zero means clear the spindle!
Pocket number –1 means: no pocket in the tool magazine!
Acknowledge with M4093.
Then the pocket number and tool number of the new, called tool are
transferred.
1
0
1
0
1
0
1
0
1
0
1
0
1
0
1
0
W264
M4541
W262
M4524
M4523
M4522
M4540
M4520
M4093
M4073
Pocket No. -1
Tool No. Ø
Pocket No. [S]
Tool No. [S]
To Next Page
Loading...
