HEIDENHAIN iTNC 530 HSCI - Page 1635

July 2013 8.15 Tool changer 1635
MANUAL TOOL
OUT program
module
M → N or M → S:
Normal or special tool follows a manual tool. The operator is prompted to
empty the spindle manually, since there is no room in the tool magazine for
the current tool. The called tool is automatically inserted.
No
Fetch tool to
GRE 1
Tool in GRE1
Prompt user to
unload tool and
press OK key
Yes
GRE1 = 0
No
Load zero in
SPIREG
(spindle empty)
Yes
M4573 = 1
No
No
Unload GRE1
TOOL CALL
strobe set again
GRE1
empty
Yes
GRE1 = P
Move axes to
manual change
position
End
OK key
pressed
Yes
STANDBY BACK
Module
TOOL CALL
feedback
CHANGE
Module
Module
STANDBY