HEIDENHAIN iTNC 530 HSCI - Page 168

168 HEIDENHAIN Technical Manual iTNC 530 HSCI
The service pack consists of packed files (*.zip). The packed files are
transferred to the hard disk of the control and unpacked.
The installation of a complete software version (setup.elf or setup.omf) is
also possible via the LOAD SP soft key.
It is not necessary to convert from binary format to ASCII format.
 If you want to use the Ethernet interface for transferring the service pack
from a PC, proceed as follows:
• While in the Programming and Editing operating mode, press the PGM
MGT key.
• Press the NETWORK soft key.
• Select the PC to be connected with the arrow keys and press the CONNECT
DRIVE soft key.
• To exit the list of network drives, press the END soft key.
• To exit the program manager, press the END soft key.
 While in the Programming and Editing operating mode, press the MOD key.
 Press the LOAD SP soft key.
 In the upper part of the window, select the folder containing the *.zip file of
the service pack. The folder contents are displayed in the lower part of the
window.
 To switch to the lower part of the window, press the FILES soft key. To
return to the upper part of the window, use the PATH soft key. In the lower
part of the window, select the *.zip file of the service pack with the cursor
keys and press ENT. The installation of the service pack starts.
 Service pack installation finishes.
Note
When installing a service pack, it is not necessary to convert the binary
format to ASCII format or vice versa, or to make a back-up of the non-
volatile operands.