26 HEIDENHAIN Technical Manual iTNC 530 HSCI
New: MP 2710.x – Only CC 6xxx:
ACC: Selection of principle of function of automatic mode
Only valid if bit 4 is set in MP2700
Input: 0 = Robust standard mode with an average
application of a damping signal
(recommended setting)
1 = Chatter damping is increased for the selected
axis. In some cases this is useful for one or
two axes (e.g. vertical axes),
but it slightly reduces the control
precision (slightly higher following error).
2 = Chatter damping is significantly increased for
the selected axis. This is usually advisable
for no more than one axis,
but it slightly reduces the control
precision (increased following error).
New: MP4020, bit 17 – PLC functions
MP4020, bit 17, is used to suppress the message "Debug functions of the
PLC are active" if MP4753 = 1 has triggered this message.
Enhanced: MP7261.x = Number of pockets in magazine
The indices MP7261.8 to MP7261.15 were added to MP7261.
Enhanced: MP7330.x – Definition of the user parameters 1 to 16
The input range was increased to 99999.00 maximum.
Input: 0 to 99999.00 (no. of the user parameter)
New: MP7412 – Settings for cycles
Bit 0 of MP7412 is used to influence the behavior of marker M4031 in Cycle
209. If bit 0 is set, the marker M4031 is set before the spindle orientation
(M05) in Cycle 209.
Bit 0: Behavior of M4031 in Cycle 209
Input: %0000000000000000
0 = Behavior as before
1 = Set M4031 before the spindle orientation
Enhanced: MP7481.x – Sequence for new and returned tool when
changing tools
The indices MP7481.8 to MP7481.15 were added to MP7481.
Enhanced: MP7484.x – Search sequence in tool magazines
The indices MP7484.8 to MP7484.15 were added to MP7484.
New: MP7266.44 – Elements of the tool table
MP7266.44 is used to show or hide the column for the new function Active
Chatter Control (ACC).
Input: 0 or 1
New: MP7268.x – Sorting/hiding columns of the preset
table
MP7268.x is used to hide the columns of the preset table, or to sort them
as desired. MP7268.x is used to define the sequence of the columns. If
MP7268.x = 0, the respective column is not displayed and is not saved
during external data backup.
Input: 1 to 99
0 = Do not display the column
To Next Page
Loading...
