272 HEIDENHAIN Technical Manual iTNC 530 HSCI
HEIDENHAIN recommends:
Preferably use a conductor cross section of 0.34 mm
2
if you use stranded
wires with wire-end sleeves. This cross section can be clamped
appropriately and ensures a reliable terminal connection.
If you use stranded wires with wire-end sleeves and a conductor cross
section of 0.5 mm
2
, the Weidmüller PZ 6/5 crimping pliers (setting 0.25–0.5
mm
2
) must be used for crimping. In this case, orient the crimped wire-end
sleeve before inserting it into the socket connector. If crimping pliers from
other manufacturers are used for crimping conductors with a cross section
of 0.5 mm
2
, the crimped wire-end sleeves cannot be inserted into the
socket connector and clamped appropriately, and therefore do not result in
a reliable terminal connection.
To Next Page
Loading...
