476 HEIDENHAIN Technical Manual iTNC 530 HSCI
If there is more than one input value for a single function (e.g., a separate input
for each axis), the parameter number is extended by indices. Index zero is
always axis 1, index one is axis 2, etc.
Example:
Enter into OEM.SYS, using the code word AXISNUMBER =, the number of axes
being used, so that only the necessary index parameters are displayed.
With other machine parameters you can activate specific functions. In this
case, the parameters serve as on/off switches for these functions. These
parameters are bit-encoded. Each bit is assigned either to an axis or a function.
MP1010.x Rapid traverse
MP1010.0 Rapid traverse for axis 1
MP1010.1 Rapid traverse for axis 2
MP1010.2 Rapid traverse for axis 3
MP1010.3 Rapid traverse for axis 4
MP1010.4 Rapid traverse for axis 5
MP1010.5 Rapid traverse for axis 6
MP1010.6 Rapid traverse for axis 7
MP1010.7 Rapid traverse for axis 8
MP1010.8 Rapid traverse for axis 9
MP1010.9 Rapid traverse for axis 10
MP1010.10 Rapid traverse for axis 11
MP1010.11 Rapid traverse for axis 12
MP1010.12 Rapid traverse for axis 13
MP1010.13 Rapid traverse for axis 14
MP1010.14 Rapid traverse for axis 15
MP1010.15 Rapid traverse for axis 16
MP1010.16 Rapid traverse for axis 17
MP1010.17 Rapid traverse for axis 18
To Next Page
Loading...
