726 HEIDENHAIN Technical Manual iTNC 530 HSCI
The tool dimensions (e.g. tool length) in the tool table are automatically
included in machining from this point on.
Transformations can be entered in the TOOLFILE table. If software option 40
has been activated (as in the table above), then collision objects (CMO) can
also be entered.
The structure of these tables is identical to that of the description tables, but
with the restriction that TOOLFILEs and SUBFILEs cannot be included in them.
The kinematics description of a TOOLFILE becomes active at the point from
which it is included within the description table. Since the tool is at the
beginning of the transformation chain, a TOOLFILE is only useful if it is included
in the first line of the description table.
If no tool-carrier kinematics are referenced in the tool table (no entry in the
KINEMATIC column), then the TOOLFILE entry in the description table has no
effect.
In the following representation, the TOOLFILE referenced via the KINEMATIC
column of the tool table is included in the description table.
To Next Page
Loading...
