HEIDENHAIN iTNC 530 HSCI - Page 830

830 HEIDENHAIN Technical Manual iTNC 530 HSCI
HEIDENHAIN generally recommends using the MP12xx machine parameters
for the nominal position value filters. The following table provides an overview
of the parameters.
MP Function Possible input value
1200 Selection of the filter type 0 = Single filter
1 = Double filter
2 = HSC filter
3 = Advanced HSC filter
1201 Nominal position value filter in manual
operation
0 = Single filter
1 = Double filter
1202.0
1202.1
Tolerance for contour transitions at corners
With machining feed rate
With rapid traverse
0.0000 to 3.0000 [mm]
0.0000 to 3.0000 [mm]
1210 Limit frequency for single filter 0.0 to 166.0 [Hz]
1211 Limit frequency for double filter 0.0 to 166.0 [Hz]
1212 Limit frequency for HSC filter 0.0 to 166.0 [Hz]
1213 Limit frequency for advanced HSC filter 0.0 to 166.0 [Hz]
1218.x Cutoff frequency for single filters of rotary
axes
0.0 to 166.0 [Hz]
1222 HSC filter: Tolerance for curvature
transitions
0 = Do not include the tolerance
1 = Include the tolerance
1223 Advanced HSC filter: Tolerance for curvature
transitions
0 = Do not include the tolerance
1 = Include the tolerance
1230.x Max. permissible axis-specific jerk for single
filter
0.1 to 1000.0 [m/s
3
]
1231.x Max. permissible axis-specific jerk for
double filter
0.1 to 1000.0 [m/s
3
]
1232.x Max. permissible axis-specific jerk for
HSC filter
0.1 to 1000.0 [m/s
3
]
1233.x Max. permissible axis-specific jerk for
advanced HSC filter
0.1 to 1000.0 [m/s
3
]
1240.x Max. permissible axis-specific jerk at
curvature transitions for single filter
0.1 to 1000.0 [m/s
3
]
1241.x Max. permissible axis-specific jerk at
curvature transitions for double filter
0.1 to 1000.0 [m/s
3
]
1242.x Max. permissible axis-specific jerk at
curvature transitions for HSC filter
0.1 to 1000.0 [m/s
3
]
1243.x Max. permissible axis-specific jerk at
curvature transitions for advanced HSC filter
0.1 to 1000.0 [m/s
3
]
1250.x Factor for axis-specific jerk at corners at
rapid traverse (from value in MP123x.x)
0.0000 to 30.0000
1262 Filter order used for HSC filters
(only useful if LIFTOFF is used during
powerfail with CC 6xxx)
15 to 31
1263 Filter order used for advanced HSC filters
(useful only if LIFTOFF is used during
powerfail with CC 6xxx)
15 to 31