970 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP3412.1 Multiplier for MP3411 during spindle orientation
Input: 0 to 1.999
MP3415.1 Spindle overshoot behavior during orientation
Input: 0 to 1000 [ms]
MP3420 Spindle positioning window
Input: 0 to 360.0000 [°]
MP3430 Deviation of the reference mark from the desired position
(spindle preset)
Input: 0 to 360 [°]
MP3440.0-7 k
v
factor for spindle orientation for gear ranges 1 to 8
Input: 0.1 to 10 [(1000°/ min) /°]
MP3520.1 Spindle speed for oriented stop
Input: 0 to 99 999.999 [min
–1
]
With Module 9171 you can specify the speed, nominal position and direction
of rotation for spindle orientation.
M4130 is set as long as the positioning movement lasts.
Set Reset
M4000 Spindle in position NC NC
M4012 Open the spindle control loop PLC PLC
M4015 Renewed evaluation of the spindle
reference mark
PLC NC
M4017 Servo-controlled spindle in motion NC NC
M4018 Reference mark for spindle not yet
traversed
NC NC
To Next Page
Loading...
