Rohde & Schwarz R&S ZNA Series - Page 1237

Command reference
R&S
®
ZNA
1237User Manual 1178.6462.02 ─ 29
<DispEl> Display Element
7 Vertical Range Lines
8 Diagram Title
9 Limit Fail Trace Color
10 Limit Line Type Off
11 Limit Line Type Upper
12 Limit Line Type Lower
13 to 12+N Trace properties 1 to N, where N is the number of trace colors configured using
SYSTem:DISPlay:TRACes:CCOunt
DISPlay:CMAP:TRACe:COLor[:STATe] <Boolean>
Defines the trace color schemes in different diagram areas.
Parameters:
<Boolean> OFF - independent color scheme in new diagram area. Moved
traces change their color.
ON - color scheme in new diagram area continues the previous
color scheme. Moved traces keep their color.
Example:
*RST; :DISP:CMAP13:RGB 1,0,0
Create diagram area no. 1 (with default trace showing the S-
parameter S
21
) and color the trace red.
DISP:CMAP:TRAC:COL OFF; :DISP:WIND2:STAT ON
Select independent color schemes for new diagram areas. Cre-
ate a new diagram area no. 2.
CALC:PAR:SDEF 'Trc2', 'S11'; :DISP:WIND2:TRAC2:
FEED 'TRC2'
Create a new trace named Trc2 and display the trace in a new
diagram area no. 2. The new trace is red like the first trace.
DISP:CMAP:TRAC:COL ON; :DISP:WIND3:STAT ON
Continue the same color scheme in new diagram areas. Create
a new diagram area no. 3.
CALC:PAR:SDEF 'Trc3', 'S22'; :DISP:WIND3:TRAC3:
FEED 'Trc3'
Create a new trace named Trc3 and display the trace in a new
diagram area no. 3. The new trace is not red.
Manual operation:
See "General > Trace Colors per Diagram" on page 849
DISPlay:CMAP:TRACe:RGB <TraceName>, <Red>, <Green>, <Blue>[,
<TraceStyle>[, <TraceWidth>]]
Defines the color, style and width of a trace referenced by its name, based on the Red/
Green/Blue color model. Use the generalized command DISPlay:CMAP<DispEl>:
RGB to define the color of other display elements.
SCPI command reference