Rohde & Schwarz R&S ZNA Series - Page 1634

Command reference
R&S
®
ZNA
1634User Manual 1178.6462.02 ─ 29
SYSTem:DISPlay:TRACes:CCOunt <ColorCount>
Defines the maximum number of trace colors (trace properties for the user defined
color scheme defined using DISPlay:CMAP<DispEl>:RGB.
Parameters:
<ColorCount> Range: 1 to 100
Manual operation: See "Number of Trace Colors" on page 862
SYSTem:DISPlay:UPDate <Activate>
Switches the display on or off while the analyzer is in the remote state. The command
has no effect while the analyzer is in the local operating state.
Tip: Switching off the display speeds up the measurement. This command may have
an impact on the update of trace and channel settings; see SYSTem:SETTings:
UPDate.
Parameters:
<Activate> ON | OFF - switch the display on or off. If the display is switched
on, the analyzer shows the diagrams and traces like in manual
control.
ONCE - switch the display on and show the current trace. This
parameter can be used for occasional checks of the measure-
ment results or settings. The measurement is continued, how-
ever, the measurement results are not updated. Compared to
the ON setting, ONCE does not slow down the measurement
speed.
Example:
SYST:DISP:UPD ON
Switch the display on to view the traces and diagrams.
SYSTem:DISPlay:XLABels <Boolean>
Enables or disables the display of X-axis grid labels in cartesian diagrams with linear
scale.
Parameters:
<Boolean> ON (1)
Show X-axis grid labels
OFF (0)
Don't show X-axis grid labels
*RST: OFF
Manual operation: See "Show X-Axis Grid Labels" on page 862
SYSTem:ERRor:ALL?
Queries and at the same time deletes all entries in the error queue.
SCPI command reference