Rohde & Schwarz R&S ZNA Series - Page 1645

Command reference
R&S
®
ZNA
1645User Manual 1178.6462.02 ─ 29
Parameters:
<RecallSetFile> String parameter to specify the absolute or relative path of the
recall set file to be loaded. Relative paths are evaluated relative
to the current directory (see MMEMory:CDIRectory).
Example: See SYSTem:PRESet:USER[:STATe]
Manual operation: See "Preset Configuration" on page 857
SYSTem:PRESet:USER[:STATe] <Boolean>
Determines whether a factory or a user-defined preset is performed.
This setting applies to the analyzer GUI and to the remote commands *RST and
SYSTem:PRESet[:DUMMy], if SYSTem:PRESet:REMote[:STATe] is set to ON.
Parameters:
<Boolean> OFF (0)
A factory preset is performed.
ON (1)
A user-defined preset is performed, if the setup file selected
using SYSTem:PRESet:USER:NAME is available and valid. Oth-
erwise, a factory preset is performed.
Example:
SYST:PRES:USER:NAME 'C:\Users\Public\Documents
\Rohde-Schwarz\ZNA\RecallSets\Setup_2.znxml'
Select a setup file for the user-defined preset.
SYST:PRES:USER ON
Enable the user-defined preset.
SYSTem:PRESet:REMote ON
Align *RST (and SYSTem:PRESet) to the user-defined preset.
*RST
Perform the user-defined preset.
Manual operation: See "Preset Configuration" on page 857
SYSTem:SETTings:UPDate <Activate>
Initiates an immediate update of the channel or trace settings.
The command has an effect if the analyzer operates in single sweep mode
(INITiate<Ch>:CONTinuous OFF) and if the display update is switched off
(SYSTem:DISPlay:UPDate OFF). In this scenario, a change of the channel or trace
settings is usually not taken into account immediately. The analyzer waits until the end
of the current sweep sequence and changes all settings made during the last sweep
period when the next single sweep sequence is initiated. Several settings can be made
en bloc, which generally saves time.
SYSTem:SETTings:UPDate ONCE causes the analyzer to apply the settings at once
without waiting for the end of the current single sweep sequence. The command has
no effect in continuous sweep mode or if the display update is switched on.
SCPI command reference