Rohde & Schwarz R&S ZNA Series - Page 1635

Command reference
R&S
®
ZNA
1635User Manual 1178.6462.02 ─ 29
The entries consist of an error number and a short description of the error. Positive
error numbers are instrument-dependent. Negative error numbers are reserved by the
SCPI standard; see section Error messages and troubleshooting.
Example:
SYST:ERR:ALL?
Query all entries in the error queue. 0,"No error" is returned
if the error queue is empty.
Usage: Query only
SYSTem:ERRor:COUNt?
Gets the current number of entries in the SCPI error queue.
Usage:
Query only
SYSTem:ERRor:DISPlay:ERRor
<Boolean>
SYSTem:ERRor:DISPlay:INFO <Boolean>
SYSTem:ERRor:DISPlay:WARNings <Boolean>
Selectively disables or enables the display of information popups for the related event
type (Information, System Error, Warning).
Note that the display of information popups can be globally disabled/enabled using
SYSTem:ERRor:DISPlay:STATe OFF/ON.
Parameters:
<Boolean> ON | OFF - enable/disable display of information popups for the
related event type
*RST: ON
Example:
SYST:ERR:DISP:STATe ON; ERR ON; WARN:OFF; INFO
OFF
Display information popups for system errors, but not for warn-
ings and information messages.
Manual operation: See "Show Info Messages / Show Warning Messages / Show
Error Messages" on page 864
SYSTem:ERRor:DISPlay[:REMote] <Boolean>
Disables or enables the display of information popups for remote control errors. These
popups appear at the bottom of the remote screen and the manual screen.
Note
●
Display of information popups can be globally disabled/enabled using SYSTem:
ERRor:DISPlay:STATe OFF/ON
●
For SCPI error -113, Undefined header no tooltip is displayed
SCPI command reference