Rohde & Schwarz R&S ZNA Series - Page 1312

Command reference
R&S
®
ZNA
1312User Manual 1178.6462.02 ─ 29
MMEMory:STORe:TRACe:OPTion:PLUS <arg0>
This command defines how positive numbers are prefixed during Touchstone file
export: by a leading space, a plus sign or not at all.
Parameters:
<arg0> SPACe | PLUS | VOID
Manual operation: See "Positive Number Prefix" on page 867
MMEMory:STORe:TRACe:OPTion:SSEParator <Boolean>
This command defines whitespace insertion during Touchstone file export.
If set to ON, separator lines are skipped, i.e. the content parts are no longer separated
by blank lines.
Parameters:
<Boolean>
Manual operation: See "Skip Separator Lines" on page 867
MMEMory:STORe:TRACe:OPTion:TABS <Boolean>
This command defines whitespace insertion during Touchstone file export.
If set to ON, columns are separated by tabs rather than spaces.
Parameters:
<Boolean>
Manual operation: See "Use TAB (instead of blanks)" on page 867
MMEMory:STORe:TRACe:OPTion:TRIM <Boolean>
This command defines whitespace insertion during Touchstone file export.
If set to ON, whitespace at the beginning of each line is removed.
Parameters:
<Boolean>
Manual operation: See "Trim Leading Whitespace" on page 867
MMEMory:STORe:TRACe:PORTs <Channel>, <TouchstoneFile>, <Format>[,
<ModeImpedance>, <Port>[, <Port>]...]
Generates an snpTouchstone file, where n is the number of specified ports.
If the specified physical ports comprise at least one balanced port and MMEMory:
STORe:TRACe:OPTion:BALanced is ON, the Touchstone file contains the full set of
mixed mode S-parameters. Otherwise it contains the full set of single-ended S-param-
eters. Both sets have a size of n
2
.
SCPI command reference