Rohde & Schwarz R&S ZNA Series - Page 1311

Command reference
R&S
®
ZNA
1311User Manual 1178.6462.02 ─ 29
Parameters:
<Boolean>
MMEMory:STORe:TRACe:OPTion:COMMent <Comment>
Defines a comment to be added to (the comment section of) exported trace files.
This is a global setting, i.e. the comment string is used for each trace export in every
open recall set.
Parameters:
<Comment> Comment string. If empty, no comment will be added.
Manual operation: See "Comment Added to File" on page 473
MMEMory:STORe:TRACe:OPTion:DECimals:DATA <NumDecimals>
MMEMory:STORe:TRACe:OPTion:DECimals:STIMulus <NumDecimals>
Defines the number of decimal places for stimulus and data values in all supported
trace data files (Touchstone, ASCII, MatLab)
Note that in the current implementation of the Touchstone file export, only the L11 file
format supports independent settings for stimulus and data values (see MMEMory:
STORe:TRACe:OPTion:FORMat). For the F11 and F20 formats, the DATA number of
digits is used for both stimulus and data values.
Parameters:
<NumDecimals> Range: 1 to 15
Manual operation: See "Decimal Places" on page 471
MMEMory:STORe:TRACe:OPTion:FORMat <TS_Frmt>
Selects the file format to be generated during Touchstone export.
Parameters:
<TS_Frmt> F11 | F20 | L11
F11
Trace output according to Touchstone standard 1.1 (new library)
F20
Trace output according to Touchstone standard 2.0 (new library)
L11
Legacy Touchstone 1.1 output
F11 and L11 slightly differ w.r.t. casing, number formatting and
comments. F20 adds keywords etc. introduced with Touchstone
standard version 2.0.
Manual operation: See "File Format" on page 471
SCPI command reference