Rohde & Schwarz R&S ZNA Series - Page 1426

Command reference
R&S
®
ZNA
1426User Manual 1178.6462.02 ─ 29
Suffix:
<Ch>
.
Channel number
Parameters:
<TestPort> Port number
Example: See [SENSe<Ch>:]FREQuency:COMPression:POINt
on page 1423.
Manual operation: See "Driving Port/Receiving Port" on page 394
[SENSe<Ch>:]FREQuency:CONVersion <ConversionMode>
Enables a frequency conversion measurement mode for channel <Ch>.
Suffix:
<Ch>
.
Channel number
Parameters:
<ConversionMode> FUNDamental | ARBitrary | MIXer | IMODulation
FUNDamental
Measurement of the fundamental signal (non frequency-convert-
ing mode). This selection cancels all port-specific frequency and
power settings (see example).
ARBitrary
Frequency conversion mode (arbitrary port frequencies). This
mode is automatically activated when a port-specific frequency
is defined.
MIXer
Mixer mode, configured using
[SENSe<Ch>:]FREQuency:CONVersion:MIXer... com-
mands.
For vector mixer measurements, set [SENSe<Ch>:]PHASe:
MODE to COHerent.
IMODulation
Intermodulation measurement mode, configured using the
[SENSe<Ch>:]FREQuency:IMODulation... commands.
*RST:
FUNDamental
Example: See SOURce<Ch>:FREQuency<PhyPt>:CONVersion:
ARBitrary:IFRequency
Manual operation: See "OK" on page 412
[SENSe<Ch>:]FREQuency<Pt>:CONVersion:ARBitrary <Numerator>,
<Denominator>, <Offset>, <SweepType>
Defines the receiver frequency formula at port <Pt> for frequency-converting measure-
ments.
For <SweepType> SWEep, the receiver frequency f
r
is calculated according to
SCPI command reference