Rohde & Schwarz R&S ZNA Series - Page 1433

Command reference
R&S
®
ZNA
1433User Manual 1178.6462.02 ─ 29
Suffix:
<Ch>
.
Channel number
Parameters:
<InputOutput> RF | LO | LO1 | LO2 | IF
Fixed frequency for the specified port
RF – mixer input signal
LO | LO1 – local oscillator signal no. 1
LO2 – local oscillator signal no. 2, for 2-stage mixer measure-
ments ([SENSe<Ch>:]FREQuency:CONVersion:MIXer:
STAGes)
IF – mixer output signal
Range: Depending on the instrument model [Hz]. The incre-
ment (parameters UP or DOWN) is 0.1 kHz.
*RST: Minimum of the analyzer's frequency range
<FixedFrequency> Default unit: Hz
SCPI command reference