Rohde & Schwarz R&S ZNA Series - Page 1569

Command reference
R&S
®
ZNA
1569User Manual 1178.6462.02 ─ 29
ATTenuation
Source or receiver attenuation
CPOWer
Cal Power for frequency sweeps
CFRequency
Cal Frequency for power sweeps
TSTamp
Timestamp in UTC
LTSTamp
Timestamp in local time
TVNA
For calibrations involving switch matrices, this indicates the test
ports on the VNA itself. Returns a comma-separated list of port
pairs TestPort,VnaPort
MVNA
For calibrations involving switch matrices, this indicates the
mapping between matrix ports and VNA ports for matrix
<Index>. Returns a comma-separated list of port pairs
MatrixVnaPort,VnaPort
MTESt
For calibrations involving switch matrices, this indicates the
mapping between matrix (physical) test ports and test ports for
matrix <Index>. Returns a comma-separated list of port pairs
MatrixTestPort,TestPort
<Index>
If one or more external switch matrices were used during cali-
bration, this refers to the index of a particular switch matrix (see
SYSTem:COMMunicate:RDEVice:SMATrix<Matr>:DEFine
on page 1627)
Usage: Query only
Manual operation: See "Port Overview" on page 597
SOURce<Ch>:POWer<PhyPt>:CORRection:DATA:PARameter<Wv>:COUNt?
Gets the number of available power calibrations (both source power and measurement
receiver).
Use SOURce<Ch>:POWer:CORRection:DATA:PARameter<Wv>? to retrieve the
related settings.
Suffix:
<Ch>
.
Number of the calibrated channel.
<PhyPt> This suffix is ignored.
<Wv> This suffix is ignored.
Usage: Query only
Manual operation: See "Port Overview" on page 597
SCPI command reference